ALURAMIC ceramic insulation 3030 20mm MCPCB for Osram IR/Luxeon IR

1.77

In stock

    • 0.5 €

Description

Aluramic (old name mosled extreme) PCBs are made from aluminum with chemically grown aluminum oxide ceramic (alumina) as insulation layer, which is excellent thermal conductor compared to even best classical MCPCB insulation layers (epoxy+ ceramic powder).

Advantages over copper DTP are:

  • electrically insulated – it’s possible to use LEDs with electrically non-insulated thermal pad,like OSRAM Oslon IR while maintaining DTP – like performance
  • very flat surface – this is important for very small LED packages
  • lower mass – may be beneficial in headlamps
  • higher temperature insulator resistance – because there are no laminated epoxy based layers, ceramic insulator cannot be damaged due to excessive heat

 

Note 1: Due to very high thermal conductivity on whole board area, soldering wires is more challenging; one simple solution is to preheat PCB with hot air or with soldering iron (by holding iron tip on + or – pad) and then solder wires. During soldering, PCB must be thermally insulated(piece of thick paper is good enough) from any thermally conductive objects.

Note 2: Yellow dot marks close to LED footprint represent LED cathode!

 

Specifications:
  • Footprint compatible with Osram infrared LEDs (SFH 4175-AS,SFH 4725-AS etc.), LUXEON infrared LEDs, and all other Osram 3030 LEDs
  • Aluminum oxide ceramic insulation layer – extremely low thermal resistance
  • Aluminum core – 3.3 times lighter compared to copper PCBs (1.25grams)
  • 70um copper traces
  • Gold plated contacts
  • Milled edge – flat bottom side
  • Diameter: 20.0±0.15mm
  • Thickness: 1.5mm

 

Additional information

Weight 1.5 g